Errors (on Clone)
Occasionally I use Disk Warrior 4.1 (monthly) to check my drives for errors. It seems like every-time I check my external HD (the one I clone to) has errors reported by DW, when the internal HD does not. I can repair the errors with DW, however if I clone again right afterwards and run DW I get errors that again I can repair with DW.
Is that normal?
Dazed and Confused
I've used SD now for about 3 1/2 years.
Here is the external drive information:
Disk Description : Hitachi HTS722020K9SA00 Media
Total Capacity : 186.3 GB (200,049,647,616 Bytes)
Connection Bus : USB
Write Status : Read/Write
Connection Type : External
S.M.A.R.T. Status : Not Supported
USB Serial Number : 070729D0410D
Partition Map Scheme : GUID Partition Table
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Display Modes||Rate This Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Windows equivalent to SuperDuper!?||jreffner||General||21||08-13-2009 06:36 PM|
|Please help me! Hard drive failing, cloning errors...||jasong||General||3||10-22-2007 10:24 AM|
|Using Disk Utility from Clone gets -9972 error (falsely?)||eagseags||General||6||09-08-2007 10:50 PM|
|Errors when attempting to clone drive||russb||General||2||09-01-2007 08:46 AM|
|Disk errors repoted using SD yet Disk Utility works fine.||s_dup||General||5||08-22-2005 09:02 AM|